![]() |
|
Push the opening in the support onto the central post.
The flexible plastic support surrounds the post.
Repeat all steps with the remaining two balloons. Then tie suspension line onto the ring of the central post (not shown).
Tie the other end of the line onto a ClikMagnet and position the ClikMagnet on a MagMover. (A Single MagMover mounted on a MagPole is shown).
Extend your pole. Angle the MagMover so the ClikMagnet lines up with a metal surface (a ceiling tile T-bar in this example).
The magnet will stick to the ceiling...
...and release from the MagMover.
Since only one suspension point is used with the Show-N-Sell, the arrangement naturally rotates with air currents in the room. The Show-N-Sell and MagMover system combination makes for a fast, eye-catching, space-saving display. For best results in a retail environment, change foil balloon designs occasionally to keep arrangements seasonal and fresh. Want to show more balloons? The 6-Balloon Show-N-Sell units can be attached to make displays of any length. Just feed the suspension ring of one unit through the hole in the bottom of another's central post.
When it's time to remove the display, place the MagMover corkscrew through the ring of the magnet and pull.
The corkscrew traps the ring so the Show-N-Sell display can be brought safely back to the ground for reuse with Replacement Tape. --- Back to Previous Project Page --- --- Back to Top --- |